Ashly pne-c2 Manuale Utente Scaricare il pdf

Ashly PE Amplifier

PNE-C2 Cobranet Module

Field Installation

1) Remove the four screws

from the standard input as shown.

2) Carefully pull out the installed

standard input assembly, only as

far as shown. Note the ribbon

cable shown furthest left that is

labelled "ST992". Gently remove

this and the other two ribbon cables.

3) The PNE-C2 plugs are in the

same general location as the three

standard input plugs. Plug in the

cable "ST992" first. Be sure to fully

seat each connector, applying

even pressure across the top.

Do not stress the wires.

4) Gently guide the PNE-C2 module

back into the amplifier, and fasten

the four mounting screws.

Remove Four Mounting Screws

aiHPf ^ ^ ^

. - •• • " J

TiT i it rv»- /

i * I P i

www.ashly.com

Ashly PE AmplifierPNE-C2 Cobranet Module Field Installation1) Remove the four screws from the standard input as shown.2) Carefully pull out the inst

Nessun commento

Ashly pne-c2 Manuale Utente